For a fine part, the selection of the blank affects all aspects of the part. When selecting the blank, the extreme conditions of the cold and hot conditions should be taken into account in order to reduce the processing ...
Cracks in dense stamped parts occur more often when the bending radius and bending angle are too strict. For products with a small bending width, the crack is at both ends of the width; when the bending width is large, t...
The wiper motor sparrow is small and complete, and it is a relatively complicated system. It is usually assembled from multiple parts such as a motor casing, a rotor, a reduction gear box, an output shaft, and a cover pl...
Vehicle electrical equipment, wiring problems are not easy to check, and it is not easy to repair. In general, the vehicle electrical circuit has problems, and it is necessary to rearrange and replace the entire line of ...
Metal connectors are an extension of traditional hardware products. The industry authorities are the National Development and Reform Commission and the Ministry of Industry and Information Technology. The National Develo...
Cracks in precision stamped and bent parts occur when the bending radius and bending angle are too strict. For products with a small bending width, the crack is at both ends of the width; when the bending width is large,...
As a famous China machining parts manufacturers and drawn parts suppliers,After years of decent cooperation, the enterprise has not only owned a broader market, but also has grown faster due to the shared resources and technology.
The sunroof does add cost and weight, and the weig...
more >>First, we must distinguish between energy and powe...
more >>